Cant select anything on the map while datalog is on? (FIXED)
Moderator: Gaskleppie
-
cquence
- Posts: 31
- http://phpbb3styles.net
- Joined: Sun Jun 10, 2007 2:44 am
- Location: OREGON
Cant select anything on the map while datalog is on? (FIXED)
Ok once I uploaded my .CAL on my ostrich I then switch the car KOEO and data logging enabled. Now I can not select any values on my maps. I tried highlighting values anywhere on the maps and ectunes automatically de-selects them for whatever reason. Loaded an old map from the previous tune, and this is still happening. any ideas?
Last edited by cquence on Thu May 21, 2009 2:30 am, edited 1 time in total.
Problem now (fixed!!) After still having the same problem mention above, I went ahead and started from scratch. Uninstall Netframe 3.5 and re-install a new copy Uninstall Ectune and re-install new copy followed by forced update. tested again. Loaded the CAL on the Ostrich after KOEO enabled data logging and now everything works like normal again. I can select/high-light any values in the table maps and they stay high-lighted. Now back to tuning:)
-
calvin
- <font color=gray>Site Admin</font><br><font color=green>eCtune Authorized Tuner</font>
- Posts: 4816
- Joined: Tue Apr 03, 2007 10:16 am
- Location: Paramaribo, Suriname
- Contact:
smart track was on smart track selects the cell where the ecu reads so you can just use the shortcut keys to adjust values. Useful for dyno tuning.
Regards, eCtune Team eCtune Authorized Tuner Location: Caribbean & Suriname aim:calvinPGMFI skype:ectune We remote connect to your laptop if you have problems. Best support in the world.