Ookay. . . Ectune cal is set for GM3bar, and when that map sensor in the car, it rund like crap. when I plug in the stock honda map it idles and sounds like a new car and runs really nice. I checked the wiring per the hondata write up, and It seems to be good to go. also, I tried another new Gm3bar... any ideas why shes actin like this??
sounds like the map sensor is not selected? did you select the sensor and press save?
Regards, eCtune Team eCtune Authorized Tuner Location: Caribbean & Suriname aim:calvinPGMFI skype:ectune We remote connect to your laptop if you have problems. Best support in the world.
Look at the voltage and mbar value with key on engine off, its very easy to wire them backwards cause they plugs are reverse from what makes sence. Double check all that. If your car does startup if your cursor is all the way to the right side of the map then its not wried properly.
Chris Delgado Tun'd Performance Houston Texas 713-962-8262
what is it reading in eCtune? do a key on engine off datalog for a few seconds then start the car, save the log and post it on here with you cal and I'll look at it..
Chris Delgado Tun'd Performance Houston Texas 713-962-8262
Regards, eCtune Team eCtune Authorized Tuner Location: Caribbean & Suriname aim:calvinPGMFI skype:ectune We remote connect to your laptop if you have problems. Best support in the world.
nope.. scratch that. she runs nice now. I just created a new map. DL connects now. It just wasnt there for a minute. I debugged and tested now it works. idles good and injectors are cal'd.. now it idles like a honda! thanks calvin for this great program ...until my next n00b problem oh and thanks chrisD for the help too
the car runs and idles now on the 3 bar. now I cant CAL inj's haha o well, Ill sleep on it.