data log freeze up?

blowngsr1 · Post by **blowngsr1** » Tue Sep 01, 2009 7:09 am

i have been data logging and all is well until recently, the wide-band stops reading, but everything else works fine. so i will disconnect then reconnect and i get an error that says attached device not operating. is this a software issue or do i have a flaky usb to serial dongle? its really irritating. thanks for the help in advance Wes

Post by **calvin** » Tue Sep 01, 2009 8:33 am

serial wideband innovate?

blowngsr1 · Post by **blowngsr1** » Tue Sep 01, 2009 2:51 pm

serial wideband techedge,

Post by **calvin** » Tue Sep 01, 2009 5:02 pm

do you use serial logging or just d14?

blowngsr1 · Post by **blowngsr1** » Tue Sep 01, 2009 9:20 pm

i use the serial logging,

David974 · Post by **David974** » Wed Sep 02, 2009 6:36 am

What your wide band display shows? (if you have display) stuck at 14.85?

blowngsr1 · Post by **blowngsr1** » Wed Sep 02, 2009 10:28 pm

no, the display runs as normal. the afr display on ectune freezes at what ever it last was. but the display on the techedge continues to run. i really think that is a dongle issue. i am going to wire up the voltout to the ecu. hopefully that will fix all this.