datalogger says it is recording but nothing

Post by **calvin** » Sat Nov 14, 2009 2:46 pm

Tuner and PRO are the same bin/rom. so that is not the case at all. If your tuner used an old rom the fuel values maybe off, if ignition was tuned on the dyno you can use that without a problem and just tune FUEL. boost car right? 3k rpm 8 psi is nice... i'm used to extreme big turbo's:)

jpjackson · Post by **jpjackson** » Sat Nov 14, 2009 2:46 pm

98vtec played it back on his too, but it wont play on mine

jpjackson · Post by **jpjackson** » Sat Nov 14, 2009 2:52 pm

yes i am boosted, it is a turbo xs t3 variant. the turbo is maped to my motor so it starts spooling by 2500 and it reaches full boost by 3000 to 3500. but still why wont my log play back? when it says its playing all of the controls for play back are greyed out

jpjackson · Post by **jpjackson** » Sat Nov 14, 2009 2:55 pm

i even tried creating a new map and cal file to see if maybe the one im using is corrupt. still dont work

jpjackson · Post by **jpjackson** » Sat Nov 14, 2009 2:58 pm

calvin, can you remote connect to my laptop and help me out?

xenocron · Post by **xenocron** » Mon Nov 16, 2009 10:09 am

I would try a fresh remove/install of the whole program

jpjackson · Post by **jpjackson** » Mon Nov 16, 2009 10:58 am

ok, i did a fresh install and rebooted and everything is working now. thank you

Post by **calvin** » Wed Nov 18, 2009 8:08 am

didn't i post screenshots or was that an other user?

jpjackson · Post by **jpjackson** » Wed Nov 18, 2009 8:12 am

yes you posted some screen shots for me and my log files were working for you, but my old lap top was causing the problem. thank you calvin

Post by **calvin** » Wed Nov 18, 2009 10:08 am

eCtune

datalogger says it is recording but nothing

re

re

RE

RE

re

re