My ostrich pairing test

Bindegal · Post by **Bindegal** » Tue Oct 16, 2007 7:27 am

...was successful. 1. Update Ostrich firmware to 1015 version and select the new \"eCtune Ostrich\" within eCtune. 2. Connect, Open Ostrich Info in the menu. 3. Reset vendor ID. 4. I selcted Obtain license. eCtune seemed to tell me that it had requested a license (I was connected to the Internet at the time) but I didnÂ´t see a confirmation email as I do when normally requesting an eCtune license? 5. At this point the Ostrich operations are (intentionally) not allowed as it is \"Unlicensed\". 5. Sent the serial number (cut&paste) to Calvin manually via email as I was not sure eCtune had done so automatically. 6. Received a new license.xml. 7. Installed new license. Ostrich is now licensed and I tried write and verify without problem. (test was done without access to a car though) To me it seems the system is working as intended. My conclusion: Good work! One thing though, and this is probably more related to Moates than it is to eCtune: \"normal\" Ostrich operations through the old \"Ostrich_1_2\" or Cr### didnÂ´t work for me any more after firmware 1015 was installed. I assume other vendors have to adjust their software to the new protocol or whatever. My point is: Customers/users need to be aware of this. /Allan

Post by **calvin** » Tue Oct 16, 2007 9:40 am

if you reset vendor. It will be a normal ostrich with no special commands to write. I tested with ostrich_1_2 in ectune and crome.

Bindegal · Post by **Bindegal** » Sun Oct 21, 2007 4:43 am

Confirmed, RESETÂ´ed 1015 Ostrich works on Cr###. Writing to a resetÂ´ed 1015 in eCtune was broken in 0.0.2.0.r0 but this is fixed now in r1. From R1, RESET wil now correctly show a warning that requesting a new license is required if the Ostrich must be paired again I figure the nature of this feature will probably annoy those wanting to use their Ostich for both a personal eCtune and other software... However - and more importantly - for the intended audience: personal users, it seems to work very well so far. One thing, though: Is it now possible to request the personal, OstrichÂ´ed license directly from the logger version? And does the program send an e-mail automatically now (as it does when requesting a normal license until now)? /Allan

Post by **calvin** » Tue Oct 23, 2007 5:39 pm

Allan, Reported all working intended.

Bindegal · Post by **Bindegal** » Mon Oct 29, 2007 5:35 pm

I did some more ostrich testing on 0.0.2.0.r2 and all seems to be well. I also tested normal \"tuner\" ostrich on firmware 1012, no problems at all. /Allan

Post by **calvin** » Mon Oct 29, 2007 8:01 pm

Thank you