stock b16a 57trim@7psi
Moderator: Gaskleppie
-
- Posts: 212
- http://phpbb3styles.net
- Joined: Wed May 09, 2007 3:25 pm
- Location: Witness Protection Program
stock b16a 57trim@7psi
FINALLY went to the dyno and forgot my boost controller. red line = last run blue line = first run my very first f/i tune. i think i did alright but im pissed b/c i forgot the stupid boost controller. tq came out really flat for some reason. it had no boost creep and i have no idea what cams it has. before anyone says anything i know the dyno read 9psi but the map sensor read a steady 7psi.
- JaredKaragen
- Posts: 1504
- Joined: Fri Nov 23, 2007 4:00 am
- Location: Bay Area, Ca
- Contact:
in eCtune settings, uncheck the option \"Use PA sensor\" and use 1024 as the value, then check again, you will see that 2 psi dissipear; this happened to me. Good #'s for low boost =) My buddy with an 05 Saturn ION redline says my car pulls way harder than his... so I am eager to hit up a dyno!
95 Sol Si : D16z6 : TD04H-13C 74 Civic 1200 : 100% Stock
- JaredKaragen
- Posts: 1504
- Joined: Fri Nov 23, 2007 4:00 am
- Location: Bay Area, Ca
- Contact:
- Boosted K20
- Posts: 100
- Joined: Tue Apr 10, 2007 10:33 pm
- Location: New York
-
- <font color=green>eCtune Authorized Tuner</font>
- Posts: 283
- Joined: Tue Nov 13, 2007 7:13 pm
- Location: Murfreesboro Tn
-
- <font color=green>eCtune Authorized Tuner</font>
- Posts: 161
- Joined: Tue May 08, 2007 9:00 am
- Location: ashEVILle, NC
Not much of a dyno shop if they don't have a spare MBC or five laying around they can loan you during the tune session. Your torque is flat as a strap because there's no restriction to flow on your setup, yet. When the cam, IM, turbine, compressor - or most likely log manifold - starts being a restriction you'll see the torque fall off up top.
Regards, Joseph Davis eCtune Team eCtune Authorized Tuner Location: Asheville, NC USA