Overflow Happen on Table Lookup Error message.
Moderator: Gaskleppie
-
trooper
- Posts: 5
- http://phpbb3styles.net
- Joined: Thu Apr 19, 2007 11:43 am
- Location: CA, OC
Overflow Happen on Table Lookup Error message.
has any one expeiranced this message? it seems to happen when at high rpm let off no throttle ot down shifting while still in gear? Could it be possable that the map sensor scalling is off and the vaccume is going past coloumn 1? \"Overflow Happen on Table Look up. Possiable cause mbar is lower then mbar coloumn 1 please verify in datalog. please lower the mbar in column1.\"
-
calvin
- <font color=gray>Site Admin</font><br><font color=green>eCtune Authorized Tuner</font>
- Posts: 4816
- Joined: Tue Apr 03, 2007 10:16 am
- Location: Paramaribo, Suriname
- Contact:
Isn't the msg clear? that your current mbar was lower then the mbar in the first column? Causing an overflow condition. It's be explained quite a few times on forum. Find in your datalog what your lowest mbar is during decel. And set the first column a little lower then that.
Regards, eCtune Team eCtune Authorized Tuner Location: Caribbean & Suriname aim:calvinPGMFI skype:ectune We remote connect to your laptop if you have problems. Best support in the world.
first to post about an all ready answered question. Best support ever.calvin wrote:Isn't the msg clear? that your current mbar was lower then the mbar in the first column? Causing an overflow condition. It's be explained quite a few times on forum. Find in your datalog what your lowest mbar is during decel. And set the first column a little lower then that.
OP: it's an intended function, if it wasn't there things would go wacky. BTW I found this after pressing search and typing in overflow. (I hate it when people do this, but it was too easy to find to not mention it) http://forum.ectune.com/viewtopic.php?t ... t=overflowthis is my $0.02, keep in mind that I can't spell
lol funny things is this what i was searching for, i had my afr and timing down pretty good as far as i could tell and then BAM!! the popup i was worried so i stopped and log in here to research..calvin wrote:Isn't the msg clear? that your current mbar was lower then the mbar in the first column? Causing an overflow condition. It's be explained quite a few times on forum. Find in your datalog what your lowest mbar is during decel. And set the first column a little lower then that.